Report item
Item specifics
  • Brand Name: BINYEAE
Product Description

Graphics M8 MG328 Transistor Tester Multi-function Inductor Capacitor ESR Meter

Description:


The tester uses 3.7V rechargeable lithium battery (battery model: 14500), but you can use the T-MINIUSB socket to charge the battery and power the system, is more economical and convenient for a long time in the indoor use.

Functions:

1. One key measure operation, automatically shut off the power when delay. Support for battery operation.
2. Automatic detection PNP and NPN bipolar transistor, N, P-channel MOSFET, JFET FET, diodes, two diodes, thyristors, resistors, capacitors, inductors. Automatic detection pin definitions.
3. Measurement of the bipolar transistor current amplification coefficient (B) and emission of conduction voltage (Uf). Darlington transistor can be identified by the amplification factor of the high threshold voltage and high current.
4. Can detect bipolar transistors and MOSFET\'s internal protection diodes and displayed on the screen.
5. Measuring the threshold voltage and the gate capacitance of the MOSFET.
6. Support two resistance measurements, the potential can be measured. If the potentiometer is adjusted to its end, the tester can not distinguish between the middle and the ends of the pin.
7. Resistance measurement resolution is 0.1 ohms, the maximum value is 50M ohms measurements.
8. Capacitance measurement range from 25pf to 100mF (10  UF). Resolution up to 1 pF, inductance measurement range is 0.01MH-20H, otherwise it will appear as a resistor, if inductor DC resistance is higher than 2100Ω will also be displayed as a resistor.
9. Can detect 2UF above capacitor equivalent series resistance (ESR), the resolution is 0.01 ohms. This feature is very important for the detection of the capacitor performance.
10. Can display symbols of the two diodes in the right direction, also shows the positive voltage drop.
11. For evaluation of a LED diode, positive voltage drop higher than normal. Double light emitting diode detection for double diode. Simultaneous detection of light-emitting diode will flashes.
12. Each test time is about two seconds, only large capacitance and inductance measurement will need a long time.

Correction:

Short connect three test terminal, enter the test, the screen prompts correction step. When prompted to disconnect nipple, disconnect the three test, calibration will continue, when prompted connect 100nF capacitor above in the 1-3 foot, program will automatically enter the next step. Until the end of the correction to restart, can complete the correction.

Features:

1. Using ATmega328 microcontroller.
2. 12864 character LCD display results.
3. One-key operation, automatic power off.
4. With shutdown switch, avoid battery power consumption when storage and shutdown.
5. Automatically detects PNP and NPN bipolar transistor, N, P-channel MOSFET, JFET, diodes, dual diode, thyristor SCR.
6. Automatically detects the pin layout.
7. Measuring the current amplification coefficient and the emitter electrode of threshold voltage of the bipolar transistor.
8. Darlington transistor can be identified by the amplification factor of the high threshold voltage and high current.
9. For bipolar transistors, MOSFET protection diode testing.
10. The threshold voltage value 11 and the gate capacitance of a MOSFET is measured.
11. Measured threshold voltage and gate capacitance of the MOSFET.
12. Supports two resistance measurements and symbols display, support the four numbers and units display. Both ends of the resistor symbol is the tester probes numbers (1-3). Therefore, the potential can also be measured.
13. Resistance measurement resolution is 0.1 ohms, the highest measured value is 50M ohms.
14. Can be detected and measured a capacitor. Maximum four numbers and units display. Values can be from 25pf (8MHz clock, 50pF @ 1MHz clock) to 100mF. Resolution up to 1 pF (@ 8MHz clock).
15. Can be measured two diodes at the same time, and display the correct pin layout and positive voltage step-down.
16. Can be measured more than 2uf capacitor equivalent series resistance (ESR) capacitor value. Resolution is 0.01 ohms.
17. LED detection for diode, forward voltage step-down is much higher than normal. Dual LEDs detected as double diode.
18. Can detects Zener diode, if the reverse breakdown voltage is less than 4.5V, it will appear as two diodes, can only be determined by the voltage.
19. Only one measurement to find full-bridge connection.
20. Unable to detect less than 25pf capacitor, but can used with a diode in parallel to or greater than 25pf capacitor in parallel. The measurement result is minus the shunt capacitance values.
21. Resistance below 2100 ohms can measure inductance, range from 0.01mH - 20H, but the accuracy is not good.
22. The test time is about two seconds, capacitance and inductance measurements will increase in value as the measurement time extended.

Package included:

1 x ESR meter (battery is not included)
3 x High quality test line (Color will be shipped randomly)

Note: When install the battery at the first time, you need to activate the battery.
Method 1: After install the battery, use tweezers or shorting line shorted connect the following two holes.
Method 2: After install the battery, plug the charger can also complete activate.

SKU433174SKU433174 (1)SKU433174 (11)SKU433174 (6)SKU433174 (5)SKU433174 (3)

 

 

Packaging Details
  • Unit Type: piece
  • Package Weight: 0.12kg (0.26lb.)
  • Package Size: 22cm x 15cm x 3cm (8.66in x 5.91in x 1.18in)
Shipping
Calculate your shipping cost by country/region and quantity.
Quantity: Ship to:
Packaging Details
  • Unit Type: piece
  • Package Weight: 0.12kg (0.26lb.)
  • Package Size: 22cm x 15cm x 3cm (8.66in x 5.91in x 1.18in)
Payment
We support the following payment methods. All payments made on AliExpress are processed by Alipay.